Audi key programmer for bcm2 cars: Audi and Tuareg

Description

Audi BCM2 Key Programmer

NO PC NEEDED/NO PRESSING BUTTONS – JUST PLUG THE DEVICE INTO OBD AND LEARN KEY IN 25 SECONDS

Supported models:

– Audi A4 (B8) Type 8K 2008+
– Audi A5 2007+
– Audi S5 (B8) 2009+
– Audi RS5 2010+
– AUDI RS4 2010-2012
– Audi RS6
– Audi Q5 2007+
– Audi A6 (C7) Type 4K 2010+
– Audi A7 Sportback 2010+
– Audi A8 (D4) Type 4H 2010+
– VW Tuareg Type 7P5 2010+
-Audi R8 up to 2011

The BCM2 key-learning device is dedicated to program keys for the vehicles equipped with the BCM2 module.

The key-learning device is equipped with a key programmer, which allows to pre-code the blank keys

How to use key programmer for Audi/Tuareg BCM2

1. added Alarm OFF function: DIP switch position 5 state “ON”
Alarm OFF:
========================================================
DIP switch: 12345678
DIP switch: xxxx1xxx
Alarm OFF function is set:
(step1): (DIP switch position 5 must be “ON”, all others “OFF”)
After ~10 seconds Procedure will finish with device beep & green led will go on.
========================================================

Key Learn:
========================================================
DIP switch: 12345678
DIP switch: 1x11xxBA
AB: Number Of Keys To Learn:
————————–
AB | Number Of Keys To Learn |
01 | 1 |
10 | 2 |
11 | 3 |
00 | 4 |
————————–

Key Learn procedure:
Plug device to vehicle OBDII connector.
(step1):
Reading data from the car:
After ~10 seconds device will start blinking red/yellow/green.
Unplug & Plug BCM2 power connectors (black & brown).
Procedure will finish with device beep & green led will go on.
(step2):
Making Dealer Key:
Device yellow led will start blinking.
Put Key Fob in device coil.
Procedure will finish with device beep & green led will go on.
Remove Key Fob from device coil.
(step3):
Learn Key(s) (new dealer key & old keys):
Device green led will start blinking.
Plug first key in vehicle key holder for maximum ~10 sec, then unplug.
Plug next key in vehicle key holder for maximum ~10 sec, then unplug.
…
Plug last key in vehicle key holder for maximum ~10 sec, then unplug.
Procedure will finish with device beep and green led will go on.

The device has the following modes of operation:

*program 1 to 8 keys to the car

*Check whether key is blank

*Switch the alarm OFF

Our device needs 25 seconds to learn a key, also it supports BCM2 modules

xx0907064xx, 8K0907289C

Looking for our other car key programmers